Peak V2 LED doesnt glow?

[CrazyCano]

Hi,

I recently rebuilt my Peak v2 motor and accidentally bent the copper legs that go from the circuit board to the brush hoods, i managed to bend them back without breaking them, but the LED doesnt glow any more? Have i done something wrong? Have the capacitors blown? The motor still runs fine, what should i do?

Thanks
ALex

[mr4man]

try tuning the endbell around 180 degrees.
in the instruction it says that if led not glowing then endbell on wrong way around.
if not dont worry you just will need to fir some external caps to it as the internal ones wont be working.
hope this helps
richard

[Ben Turner]

The same happened to mine and i found that some of the tracks on the PCB had been broken, but it still runs fine, although i havent put any caps on it yet.

Ben