Mission to Mi2

[mattcaney]

Are there any parts from the Mission that can be transferred to the Mi2. I have steel UJ's on my current mission and alloys hex's will these fit on the new car. Also are the diffs different as I would like to run the one way I have with the mission also they have RW pulleys. Thanks

[neveo]

The steel UJ's & the Alloy hex's will fit yes. The Diff sizes on the Mi2 are bigger than the mission unfortunatly. Also the Mi2 comes with RW pulleys :cool:

Hope this helps

[MattW]

neveo - Sorry but that info is incorrect.

The driveshafts and hex's will fit, although personally i didn't run steel driveshafts anyway on my mission, and don't now on my Mi2.

The one-way is different. The Mission one can be made to fit, but it doesn't fit properly and can cause other problems so i wouldn't recomend it. The bearings need to be removed and then bonded in the other outdrive. I did actually try to get some out and couldn't ;)

The Diff pullies that come with the Mi2 are still moulded ones. However they are much improved moulded ones over the origional Mission parts. The diffs are all physically the same size, but the position that the belts run on are sometimes slightly different. I have seen an origional Mission RW machined rear pully on an Mi2. I haven't tried it myself so i am not sure if it is straightforward or not. I have tried to put a front mission RW pully on, and it isn't possible to get it right due to the belts running at different spacings.

There will be some Mi2 specific Machined pullies available in due course, although i am not sure when.

[neveo]

I read somewhere that the Mi2 pulleys were machined :confused:

[MattW]

Sorry - Nope not the kit ones.