Finally Finished, What Next?

[Simon Goodey]

Ive finally finished building my new CGM it looks great after making a mistake with the set screws my rear tyers didnt even touch the floor lol ive sorted that the intructions are clear I was in a hurry lol anyone else got any advice on setup guides etc or hop ups/spares etc?

[jonny69]

Get some C hubs, hub carriers and maybe some wishbones. Top tip. Superglue or threadlock the shoulder screws which pass through the C-hub into the hab carrier, the ones on the bottom have a habit of falling out. Jonathan

[Simon Goodey]

yeah the screws dnt look to close to keeping them in lol and by c hubs u mean the shoulder arms or do u mena the bit which hold the drive shaft to the wheel?

[jonny69]

The C-hub is the bit that the camber link attaches to on the top, I think they have 3 steps on them and are only on the front. Jonathan

[cobra81li200]

C-Hubs are castor blocks. They're mad out of graphite on the CGM and you'll hardly break one.

As for hubs, you should get hold on a pair of SD415SG, they're the 0mm trail in graphite, they'll give more steering.

SO far, I only broke wishbones on the car, only on huge crashes.

[Simon Goodey]

so get how many of each c hub and hub carrier and is that it and any hop ups?

[Simon Goodey]

C-Hubs are castor blocks. They're mad out of graphite on the CGM and you'll hardly break one.

As for hubs, you should get hold on a pair of SD415SG, they're the 0mm trail in graphite, they'll give more steering.

SO far, I only broke wishbones on the car, only on huge crashes.

Will my local model shop do the hubs do u recon are they common? and can they be used only for the reat though aint it?

[cobra81li200]

I don't know if your hobby shop will have them, they're an option part.

SD415 are the normal plastic hubs (1 front 1 rear),
SD415G are the same but made out of graphite reinforced material,
SD415S are FRONT hubs with 0mm trail, plastic,
SD415SG are the same but graphite.

I usually get them from the US or japan, as they're almost impossible to get hold on here.

[Simon Goodey]

id get the SD415SG do you know any places I can get some from?

[Doomanic]

All the parts listed are now available from CML.

[Simon Goodey]

can u get them in Dom?

[Doomanic]

I've got some of them, I'll check tomorrow.

[Simon Goodey]

ok i might buy them with the batts