xxx-4 setup

[Southwell]

I tried my xxx-4 first proper meeting on sunday and was very impressed! But i having problems with the rear end which makes it hard to drive quickly.
It has very little off power grip but loads of on power. If i move the shocks to the outer hols on the wishbone and take my limiter out of the shock will it make the any better?
I upgraded to the G+ towers and shocks whereas with the standard shocks and towers i didnt have this problem!

Any help appreciated

[Doughty]

what lenght shock shafts are you running the in back now?

[Southwell]

1.0 changed from 1.2 as per instructions......

[Doughty]

Thats fine
If I remember correctly you should run them with no limitors on the inside hole (wishbone)

That might help.

[Southwell]

Cheers ill give it a go.

[richard_cree]

Don't be worried about running the 1 degree hubs on the back too, these spend sizeable portions of time on the back of my car when its not on astro!

[Southwell]

What degree pivot blocks do you normally run?

[turbotim]

hi,

ive been running the bk2 rear end on mine and found loads off rear end grip just by mov ing the outer hinge pins. ive left the shock in the stock hole positions.

[super__dan]

I'm only just getting up to speed on the XXX4 after years of ignoring what was happeningin 4wd. I need to get some rear toe in blocks as I had 2*right ones in the kit. Is it worth just getting the std ones or are there some different ones that are better?

Dan