Have New Xrayt1r Help!!!

[tonynearly49]

Have been put new T1R together and have found that the rear drive shafts C clip only just sits in the rear diff the width of the rear wheel base also seems very wide!! any ideas on what I may have done wrong?

[Doomanic]

It sounds like you have attached the pivot blocks to the outside of the bulkheads.
They should be on the inside.

[tonynearly49]

hi Doomanic
The pivot blocks are on the inside of the bulkheads. have just measured the rear width and it is 190mm from Hex to Hex. the front fits nicely and is 175mm

[Doomanic]

Hmmm, are the rear hubs on the right way round?

[tonynearly49]

Spot on thats what the problem was ;D

everything looks fine now

Thanks a Lot :) :) :)

[Doomanic]

No problem.
It had to be something silly like that as they go together sooo well. ;D