PDA

View Full Version : World GT - Rule Set - IIC 2008



Amc
25-06-2008, 01:58 PM
THOUGHT I WOULD LIST THE RULE SET FROM LAS VEGAS AS THE OUTLINE RULE SET FOR RUNNING THE NEW 200MM PRO TEN STYLE CARS. I THINK THE 235MM SHOULD REMAIN AS THE LMP STYLE BODIES LIPO AND NO MOTOR LIMIT. SO THIS THREAD IS ABOUT A WORLD GT CLASS RULE SET. ALSO LOOKING FOR A CLUB WILLING TO RUN A ROUND ?


Chassis
1) Suspension
a) Front End must be “sliding king pin style”. No independent A-Arms.
b) Rear End must be “solid straight axle with integral differential”.
2) Width 200mm at maximum
3) Wheelbase (length) must be within 10” to 10.5”, axle center to axle center.
4) Weight Minimum (Ready to Run with Body) = 2lbs 8oz. or 40oz.
5) Minimum Ride Height 4mm (Ground to underneath Chassis)
6) Roll Over antennas are not allowed

Body
1) Maximum Width 205mm

2) Minimum Roof Height (Ready to Run) 95mm
3) Wing Max Width 200mm
4) Wing Max Chord 45mm
5) Wing Max Side Dam 45mm x 20mm
6) Wing must be fastened to the rear deck of body
7) Rear Wing may not be higher than roof height
8) Rear of body may not be cut less than 35mm from rear deck lid
9) Approved World GT Body List for IIC 2008
1) Protoform Chevy Corvette C6 #1499
2) Protoform AR8C #1502
3) Protoform MGTS #1503
4) HPI Toyota Supra GT #7486
5) HPI Dodge Viper GTS-R #7473
6) HPI Mazda RX8 #7488
7) HPI Saleen Mustang #7428
8) HPI Nissan R34 GT-R #7427

Power
1) Battery - 4-Cell Ni-MH
2) Motor – Handout Brushless 13.5 Turn

Tires/Rims
1) Jaco Spec 1/10th scale on-road foam tire/rims will be run at IIC 2008.

Race Duration
1) World GT races will be 5 minutes in length.

brownpants
28-06-2008, 12:00 PM
I asked if anyone was interested at West London and my reply was that as long as they have a minimum of 6 entrants they will run a heat for this class.
I was hoping to run mine on the 6th July as thay are running a charity meeting.
Might be good if enough people enter to start a regular thing?