Sensor Connection port

[andymurray]

Hi, I have just this minute recieved a nosram 4.5 bl motor in the post. It was a second hand job...
My problem is it seems that its previous owner has had a crash or a 'mishap' of somesort because 3 of the teeth have been bent inwards...
Also one side of the lip has been bent outwards slightly so the plastic pin on one side of the connector will not be supported i imagine.

I was just wondering if anybody knows a part number or location/ link, to where i could find just the 6pin connector..?


(I imagine that this one will cause me problems even if i was to straighten the teeth without one snapping...? correct me if i am wrong:) )

Thankyou
Andy murray

[xraydad]

The connector comes as a complete unit of the sensor board, but they are available as a spare part from shumacher under part number SPSB138, and is about £14 plus vat. Shumacher are doing teardown units of the popular GM/ORION/NOSRAM units, so spares are a little easier to come by. Check out their web site under brushless motors.
Hope it helps.

[MattW]

The speed passion parts from Schumacher will not fit a LRP/Nosram motor.

I think if you check the EB rules it does list the part number for the connector i think - as it has to be a standard follwed by all the manufactures.

[Skiddins]

I would start by just trying the bend the pins back to straight with some needle nose pliers, they should be fine to do once, each time you straighten them they get slightly weaker.

Skiddins