carpet setup using foams

[mr4man]

anyone got a godd carpet setup using foams?
have a reasonable one at mo but finding rear tends to slide in corners that need rapid direction changes.

front gt4 green springs 23lb 50wt oil 3 hole pistons 62mm long
rear tower on front using upper middle hole and 2nd in on wishbone.
camber link in lower inner midlle on c hub
no role bars 1deg camber
rear mr4 green springs 14lb 50wt oil 3 hole pistons 62mm long
upper outer on tower 3rd hole on wishbone.
no rolll bar 2deg rear toe in 1deg camber.
has 40shore front 35 shore rear foams 26mm wide.
ball diffs all round 5.5 mm ride hight .

[MattWinyard]

Try a 3 degree toe in on the rear to stop your rear end slip.

But you might lose a bit of top end speed.

[Dan Hughes]

I only run on a short tight track but all i have done is upgraded to graphite arms alround and it is good enough to keep up with last years tamiya eurocup winner. in your case maybe go down a spring rate on the rear. It should sit better in the corners.

[AzNDRAGster]

Try a 3 degree toe in on the rear to stop your rear end slip.

But you might lose a bit of top end speed.


Yeah, and run a .5 deg hub, making 3.5 deg. It helps cornering too. It doesn't lose any speed to the fact that its noticable.