TIR CVD's?

[Simmo]

Just bought me some TIR CVD's for my RDX, I have noticed that when I wheel nut the ALU hex tries to push into the hub bearing at the front.

I have noticed the thread on the stub axle is a little longer than the standard ones, hence the wheel nut is screwing down further (if you see what I mean)

Is there an easy way round this? other than losening the front wheels? I have flanged Nylocs on there at the moment, I am just a bit worried that currently running a spool will help the wheels fall off!!?

Any "sensible" ideas always welcome..


Si

[Chris Delves]

Hi Simon... shouldnt think you would have anuthing to worry about there in all honesty. Just dnt crank the wheel nuts on, otherwise you could crush the bearing!

[Simmo]

Yeah have noticed that, will have a try at the weekend and see how It all goes..

Cheers

Si