Solid Front Axle

[Joshua]

Ok somebody has probably asked this question(though a trawl through this forum revealed no results).
Does anyone know of a company that produces a spool for the mission?

I refuse to superglue my front diff, but bluetack does work, needs to be re-done every 2/3 race meetings though.

[marcoski]

Take the balls out, then cut four disks of sandpaper the same size as the plates. Glue two pairs of disks together so you end up with two disks with the "sand" on each side. Slip these in either side of the pulley and tighten the diff. The diff will be very effectively locked without causing any damage.

[MattW]

Titanium Racing were planning on producing one according to their web site, although i haven't seen one, so not sure if they have been finished.

You don't actually need to do anything special to make one from Schumacher parts. The one in my car is simply a diff with the main balls removed. Everything else is left as is. I have run i tlike that a few times with no problems.

[Joshua]

Thanks Guys, but going to go with the superglue as i have just bought a secondhand mission on e-bay with loads of spares including a front diff

Dave P.