RDX standard setup

[Tim Fry]

Has anyone got a kit setup sheet they could send me?

Thanks

[MikeS]

Tim, i think you will find that there isn't actually a "kit set-up" sheet published directly by Corally. It is all within the construction manual - which you can download from here: http://international.corally.com/pdf/RDX-Manual-090305.pdf

[Tim Fry]

Thanks Mike.
My reason for asking was that its not that clear in the manual where the lower shock mounting position of the front shocks is.
Obviously I want to try it in standard form first before I adjust it.

[MikeS]

Tim, check the section "Step 2" at the bottom of page 18. (hint: "(outer hole)") ;)

I am running Chris's in this position, but running hybrid shocks; Corally shafts, pistons, moulded ends, internals and springs, but RCLab GT3 shock bodies, spring platforms, alloy top caps and the "low" spring perches.

If you run OEM shocks make sure your positioning allows sufficient up travel or it will roll over every time you run a kerb!

[Tim Fry]

Tim, check the section "Step 2" at the bottom of page 18. (hint: "(outer hole)") ;)

I am running Chris's in this position, but running hybrid shocks; Corally shafts, pistons, ends and internals, and springs, but RCLab GT3 shock bodies, spring platforms, top caps and spring perches.

If you run OEM shocks make sure your positioning allows sufficient up travel or it will roll over every time you run a kerb!

Thanks Mike I should have read the text :'(
Unfortunately when I went to school everything was done in stone tablets :D