Measurements Please

[Doughty]

Strange question I know, but could someone give me the measurements of a motor?

I need the Diameter and the lenght (not including the shaft that you put the pinion on, just the can (from the mounting screws) to the end of the endbell

Thanks

[lotusmark2]

Sorry Chris totally forgot to do that for you :-[
If no joy from this post, I will do it for you tonight

[Doughty]

;D don't worry mate

[Steve Cann]

Chris

Check the Electric Board section on the BRCA web-site. Max dimensions are listed there. Strongly suspect all motors would be built to these maximums.

[Doughty]

I did have a quick look there, and I could not find anything, I will look a little closer

Thanks for you help

[Doughty]

open eyes and thou shall see! ::)

"The basic can diameter, before any surface finish is applied, is 36.02 mm. The can length is 53 mm measured from the mounting face of the motor to the furthest point of the end bell"

just to let you know though, I was looking in the wrong place!

[Luke Hobson]

don't mean to be nosey but wy d you need the mesauements?

luke

[Doughty]

just something I am planning, I dont have my RC gear with me else I would measure myself.

all should be come clear if I can find some time over the next few months.

[MattW]

He's up to something shifty ;) ;)

[al]

ooooo very shifty and sneaky

cheers al

[Luke Hobson]

tell us..

luke

[PDW]

No, don't tell us, I like surprises!!

[university_dave]

Motor size, tyre size, I think there's a new chassis in the pipline for something... ;)