xxx-s question

[Doughty]

could someone measure and tell me the distance between the two front wishbone inner mount pins please?

[gingapaint]

depends if your using the stock or other pivot block mate... i'll measure both tonight for ya ;)

[Doughty]

if you can do both that would be good,

what is the diff in the blocks? and what does it do to the width?

[gingapaint]

using a rear block on the front, brings the hinge pins parralel (or at least more paralel) and stops the car hooking mid corner... much great tweak.



edited cause my school never taught me to spell properly.

[Steve_L]

Sorry to butt in, I have my car in bits on the dining room table and my vernier handy!

Normal front block 49.3 mm
Rear block 45mm

Both measurements are are to the centres of the holes in the blocks.

[Doughty]

OK cool, thank you very much!

and its about right too! ;D - not doubting your info, just about right for the perticular application I want thats all.

thats the cool thing about www.rcracechat.com you can ask an obcure RC related question and an answer is normally there in a few hours! ;D

Cool thing number 2 - you can edit your messages to correct VERY poor typing skills! ::)

[Doughty]

Could someone give me the diameter of a xxx-s wheel and wheel+tire and the make of the tire please?