Richard Lowe
06-10-2003, 08:47 PM
Hi all,
A bit of a strange question this, but could anyone tell me the measurement between the bottom edge and the centre of the bearing on an SD motor mount? Basically I need to know how high off the chassis the input shaft is, and what diameter is the rear input shaft as it goes through the bearing?
If it fits it would speed up/simplify the design process of my off-roader massivly, and you can get them in BLOO!!!!!
You can see the mount I'm looking at by following the linkie below.....
http://www.yokomousa.com/newproducts/rayspeed/sd_rayspeed_CONV_007.jpg
Ta!
A bit of a strange question this, but could anyone tell me the measurement between the bottom edge and the centre of the bearing on an SD motor mount? Basically I need to know how high off the chassis the input shaft is, and what diameter is the rear input shaft as it goes through the bearing?
If it fits it would speed up/simplify the design process of my off-roader massivly, and you can get them in BLOO!!!!!
You can see the mount I'm looking at by following the linkie below.....
http://www.yokomousa.com/newproducts/rayspeed/sd_rayspeed_CONV_007.jpg
Ta!